Garmin GPS II - Manual (Page 70)

64
Using the Cursor to Mark and GOTO Waypoints
During panning, the crosshair represents a target position right on the moving
map, with the range and bearing to the target displayed at the top corners of the
screen. You can also use the target crosshair to mark a new waypoint position or as a
GOTO destination right from the map field.
To mark the target crosshair position as a new waypoint:
1. Press MARK (Fig. 64a).
2. Enter a name and/or route number, and press ENTER.
You can also use the target crosshair as an instant GOTO destination. Similar to
the MOB mode, this function will mark and instantly set a course for a new way-
point called ‘MAP’.
To GOTO the target crosshair:
1. Press GOTO, and press ENTER (Fig. 64b).
If you want to save the MAP waypoint, be sure to rename it because it will be
overwritten the next time a map GOTO is executed.
Fig. 64a
Fig. 64b
REFERENCE
GPS II 7/23/98 4:05 PM Page 64