Garmin GPS II - Manual (Page 97)

91
APPENDIX E
Messages (cont.)
Receiver has Failed—A failure in receiver hardware has been detected.
If this message persists, do not use the unit and take it to an authorized
dealer for repair.
Route is Full—You have attempted to add more than 30 way-
points to a route.
Route is not Empty—You have attempted to copy into a route
already in use.
Route Waypoint Can’t be Deleted—The waypoint you are
trying to delete is part of a route. Delete the waypoint from the
route before removing it from memory.
Route Waypoint was Deleted—A route waypoint entered
does not exist in the database and has been deleted from the
route.
RTCMInput has Failed—DGPS data being received has been
lost. You are no longer receiving the beacon signal.
Searching the Sky—The GPS II is in searching the sky for
almanac data or the unit is in AutoLocate mode.
Route Waypoint was Deleted—A route waypoint entered
does not exist in the database and has been deleted from the
route.
RTCMInput has Failed—DGPS data being received has been
lost. You are no longer receiving the beacon signal.
Searching the Sky—The GPS II is in searching the sky for
almanac data or the unit is in AutoLocate
TM mode.
Stored Data was Lost—All waypoints, routes, time, and
almanac data have been lost due to battery failure, or the receiv-
er’s memory has been cleared.
Transfer has been Completed—The receiver is finished
uploading or downloading information to the connected device.
WPT Memory is Full—You have used all 250 waypoints in the
GPS II. Delete unwanted waypoints to make room for new
entries.
GPS II 7/23/98 4:06 PM Page 91