Garmin APOLLO GX65 - Manual (Page 199)

the FAF if the approach has not yet been enabled.
You will then get a message to enter the local
altimeter setting.
Enable Approach - Method 2
When an approach has been loaded, the aircraft is less
than 30 nm from the destination airport, and the
approach has not yet been enabled, pressing
FPL will
result in the “Enable Approach?” prompt. If you press
SEL while in Nav or Map mode home pages, the
prompt will also appear. Press ENTER when this
prompt is displayed to enable the approach. You will
then get a message to enter the local altimeter setting.
At 30 nm from Destination Airport
1. At 30 nm from the destination airport, the MSG
annunciator will flash. Press MSG . The display will
ask if you want to “Enable approach.” Press ENTER
to enable the Approach operation. The Approach
annunciator will light and the CDI sensitivity will
automatically scale gradually from 5 nm to 1 nm
full scale.
Press ENTER to
Enable Approach
2. The display will verify that you have enabled the
selected approach. You will now be prompted to
enter the local altimeter setting. Turn the
SMALL
knob to change the barometric pressure values and
turn the
LARGE knob to move the cursor. Press
ENTER .
ENTER
Local Altimeter
Setting 29.92¯
3. Press MSG to return to the Navigation function.
9-9
Approach Basics (GX50/60)
ENTER
MSG
ENTER
MSG