Garmin APOLLO GX65 User Manual

Page 204

Advertising
background image

approach. You will now return to Approach
Transition mode. The Approach Active light will
go out and the CDI will gradually go back to
Approach Transition CDI sensitivity (from 0.3 nm
to 1.0 nm full-scale).

As soon as you enable sequencing, the Apollo GX will
sequence to the next waypoint in the flight plan. This
is the next waypoint in the published missed approach
procedure.

If the next waypoint is the MAHP, it is an automatic
holding

point

and

sequencing

will

again

be

automatically suspended. The OBS/HOLD light will
come back on. Operation will change from Approach
Active to Approach Transition.

3. Verify or select the next waypoint in your flight

plan. If the active waypoint is not the one you wish
to navigate to, select a new active waypoint. If the
active waypoint you want is already in your active
flight plan, the easiest way to select it is to press

FPL

, to enter flight plan mode. Turn the

SMALL

knob until the waypoint you want is shown as the
“TO” side of a flight plan leg . Then press

DIRECT-TO

and

ENTER

to select the waypoint.

Note

If the same waypoint appears in the
approach sequence more than once, be sure
to turn to the occurrence you wish to select.

4. If a specific inbound course to the active waypoint

is to be intercepted or flown, press

DIRECT-TO

twice.

5. Set the desired inbound course with the

LARGE

and

SMALL

knobs. If flying a holding pattern, press

OBS/HLD

. Then, press

ENTER

. Selecting an

inbound course in this manner will suspend flight
plan sequencing and the

OBS/HLD

annunciator will

light. See page 9-24 for details on holding patterns.

9-14

Approach Basics (GX50/60)

FPL

D

ENTER

D

D

ENTER

Advertising
This manual is related to the following products: