Garmin G1000 Socata TBM 850 - Manual (Page 31)

190-00709-00 Rev. A Garmin G1000 Pilot’s Guide for the Socata TBM 850 1-21
SYSTEM OVERVIEW
SENSOR Displays softkeys for selecting the #1 and #2 AHRS and Air Data
Computers
ADC1 Selects the #1 Air Data Computer
ADC2 Selects the #2 Air Data Computer
AHRS1 Selects the #1 AHRS
AHRS2 Selects the #2 AHRS
PFD Displays second-level softkeys for additional PFD configurations
DFLTS Resets PFD to default settings, including changing units to stan-
dard
WIND Displays softkeys to select wind data parameters
OPTN 1 Wind direction arrows with headwind and crosswind components
OPTN 2 Wind direction arrow and speed
OPTN 3 Wind direction arrow with direction and speed
OFF Information not displayed
DME Displays the DME information window
BRG1 Cycles the Bearing 1 Information Window through NAV1, GPS/
waypoint identifier and GPS-derived distance information, and
ADF/frequency.
HSI FRMT Provides access to the HSI formatting softkeys
360 HSI Displays the HSI in a 360 degree view
ARC HSI Displays the HSI as an arc
BRG2 Cycles the Bearing 2 Information Window through NAV2 or GPS
waypoint identifier and GPS-derived distance information, and
ADF/frequency.
ALT UNIT Displays softkeys for setting the altimeter and BARO settings to
metric units
METERS When enabled, displays altimeter in meters
IN Select to display the BARO setting as inches of mercury
HPA Select to display the BARO setting as hectopacals
STD
BARO Sets barometric pressure to 29.92 in Hg (1013 hPa if metric units
are selected)
OBS Selects OBS mode on the CDI when navigating by GPS (only
available with active leg)
CDI Cycles through GPS, VOR1, and VOR2 navigation modes on the
CDI
ADF/DME Displays the ADF/DME Tuning Window, allowing tuning of the
ADF, ADF Mode selection, ADF volume control, and selection of
the DME
XPDR Displays transponder mode selection softkeys
XPDR1 Selects the #1 transponder as active
XPDR2 Selects the #2 transponder as active