AASTRA AMC+ User guide for Android EN - Manual (Page 32)

AMC+ 2.0 User Guide 10 Settings
10.6.3 HTTPS Port
If a port is configured here and if HTTP(S) has been activated on your AMCC, data connections will be
established automatically whenever necessary(for Callbacks, to access the Corporate Contacts etc.).
10.6.4 Handover Settings
The following settings determine when a handover from a VoIP call to a cellular call (and vice versa)
is triggered.
The Disconnect Threshold determines when a call will be handed over to the cellular network, whereas
the Connect Threshold is the minimal signal strength for cellular to Wi-Fi handovers. Also taken into
consideration for handovers is the so called Alpha Value which is a correction factor for the hysteresis
function for handovers. Higher value means more responsive, lower value means sluggish handover.
Note: Normally, there should not be any need to modify these settings. However, if you think that these
handovers happen too late, i.e. if the call quality decreases too much before the handover is done, try
adjusting these settings.
10.6.5 OTA-URL
The OTA-URL is the link to the Aastra administration portal, from where the AMC+ will download
the configuration (including license), Feature file and LCR file.
10.6.6 Operator Supported Dialing (OSD)
Some operators can call your configured PBX Dialing-in number automatically. Please note that this
will only work with the SIM card for which your AMC+ was activated. If your provider supports OSD
and if you would like to use it, set this setting to On.
This will only be applied when you are not in a roaming state.
10.6.7 User Account Key
Here you can find your AMC User Account key.
32