AASTRA 610d for Aastra 400 User Manual EN - Manual (Page 61)

Supplementary features
eud-1290/1.0 – R1.0 – 01.2011
61
Setting functions by remote control
This section explains how you can alter your phone’s settings even if you are not
directly at your phone.
You are not at your desk and want to set various functions on your phone from a dif-
ferent phone.
You can activate/deactivate many of your phone's functions by remote control from a
different phone.
The remote control is initiated using a special */# procedure. You can then enter the
function commands and */# procedures.
Note:
The default PIN setting "0000" is not accepted. First change the PIN as
described in chapter
"Changing the User PIN" , page 75 or use */#
procedure *47 (see "User’s Guide */# Procedures" on the Aastra document
portal:
www.aastra.com/docfinder ). If you have forgotten your PIN, your system
administrator can reset it to the default setting.
Free seating log out: Log out free seating:
Press the Free seating log out softkey.
➔
The display with the call number is displayed.
Depending on the system configuration enter the PIN and confirm with the Ok
softkey.
➔
You are now logged off; the free seating phone is now available again to
other users.
Note:
You are automatically logged off if your system administrator has set up an
automatic logoff process.
<Setting value> Using remote control from a third-party phone:
1. Enter procedure #36.
2. Enter your phone number.
3. Enter your PIN.
4. Enter the */# procedure for activating/deactivating the function you want.
Press the Call key.
➔
Acknowledgement tone sounds; function is activated/deactivated.
Note:
The default PIN setting "0000" is not accepted. First change the PIN as
described in chapter
"Changing the User PIN" , page 75 or use */#
procedure *47 (see "User’s Guide */# Procedures" on the Aastra document
portal:
www.aastra.com/docfinder ). If you have forgotten your PIN, your system
administrator can reset it to the default setting.