AASTRA 7446ip (5446ip) for MX-ONE User Guide EN - Manual (Page 21)

IP P HONE FOR MX-ONE™
21 6/1553-DBC 446 01 Uen E8 2010-07-08
Note: The headset preset mode can only be activated and deactivated
when the phone is in idle mode. When you lift the handset to
answer an incoming call, the call is automatically connected to
the handset, regardless of which preset mode is active.
4 Starting the Phone
4.1 Starting and Logging On
Depending on the settings in your network and telephony system, the
start up procedure may differ from phone to phone. Check the display on
your phone and read the relevant sections in this chapter to continue
with the startup procedure.
When the phone is connected to the network, your phone automatically
initiates the startup procedure when the power is connected to the
phone.
After a power failure the phone restarts automatically.
Note: During power-up, the phone display is black for a little while.
LAN access control
Your phone might require a network authentication to gain access to the
network. You then have to enter a valid user identity and password.
Note: The user identity and password used for the LAN access control
are not the same as the extension number and Personal Identifi-
cation Number (PIN) or password you use to log on to the tele-
phony system. Contact the system administrator to obtain a new
password or change an old password.
1. On the main page, tap the Enter User ID field and enter your user
identity (typically the extension number).
If you need to edit the input, tap the Erase button.
2. Tap the Enter password field and enter your password. If you
need to edit the input, tap the Erase button.
Note: You can enter the password from the keypad on the phone, or
from the soft keyboard in the display.
3. Tap the Log on button to continue the startup procedure.
If your user identity and password are not accepted, an error
message is displayed. Contact your system administrator.