2 microsoft exchange 2010, 1 voice mail, 1 um dial plan – AASTRA MX-ONE V4 with Exchange 2010 Quick Setup Guide User Manual
Page 10
Quick Setup Guide
Doc. No.
ASE/MXO/PLM/ 0141/ EN Rev.C Date: 01.12.2011
10/34
call_list -i -d 21167 --dest-number 55555 --position 2
For non generic extensions it is recommended to use Call Diversion.
3.2.1.5 Enable Voice Mail and Voice Mails notification in the MX-ONE Telephony System
(MWI settings)
The voice mail extension 55555 will be used as the handle (
attribute mwf)
where to feed incoming
Message Waiting Indicator (MWI), as defined in RFC 3842. The message from Exchange 2010 UM
includes the SIP account from the user’s extension that needs to receive the message waiting
indication; that there is a voice mail to listen to.
Create the attribute mwf (message waiting function) and attach it to the voice mail extension. In
CMWC set the number to be called from an H.323 terminal in the dig parameter.
ICFUI:IFCIND=2,USER=GENERIC,ISTYPE=2,INTTYP=1;
icfuc:mwf=all;
icmwc:sid=02,dtxt=55555,dig=55555,kfcn=MWC;
vmgei:ifcind=2,dir=55555;
*For H.323 Dialog terminals: If there is no fixed key for Voice Mail on the terminal, a function key,
‘Message Waiting’ must be enabled as well in order to enable speed dial. The key is enabled in a
common phone configuration file (for example d42x02-config.txt).
For SIP 67xxi terminals: In the common phone configuration file, aastra.cfg, set “ sip line1 vmail:
55555” to enable speed dial to voice mail.
3.2.2
Microsoft Exchange 2010
After the installation of the Exchange 2010 UM role, the following steps need to be executed to create
the integration between MX-ONE and Exchange 2010 UM.
3.2.2.1 Voice Mail
In order to setup the Exchange 2010 UM Voice Mail the following steps need to be configured.
3.2.2.1.1
UM Dial Plan
A “UM Dial Plan” needs to be created in the Exchange UM.
Before you create a UM dial plan, please read the Microsoft’s document View or Configure the
Properties of a UM Dial Plan that defines each settings.
To create a New UM dial plan please follow the steps in Microsoft’s document
Example: