AASTRA MX-ONE V4 with Exchange 2010 Quick Setup Guide - Manual (Page 27)

Quick Setup Guide
Doc. No. ASE/MXO/PLM/ 0141/ EN Rev.C Date: 01.12.2011 27/34
4.2.3 Import the certificate to MX-ONE Telephony Server
Import the server certificate, in the example, sn3112.roadrunner.pfx to MX-ONE Telephony
Server accessing the Exchange 2010 UM. On the access Server, for example, Telephony
Server 1 run the command:
cert_install_local sn3112.roadrunner.pfx
4.2.4 MX-ONE configuration:
4.2.4.1 Creating SIP trunk with TLS
The following commands shall be executed in MX-ONE to configure a SIP Trunk with TLS, the
others commands are the same as in a TCP configuration.
Using TLS for SIP Direct
sip_route -set -route 55 -uristring sip:[email protected] -fromuri0
sip:[email protected] –remoteport 50061 -protocol tls -
codecs PCMA
Inbound setting:
sip_route -set -route 55 -accept REMOTE_IP -match 192.168.222.97
Note that –accept REMOTE_IP will match the IP address send in the IPv4 source IP header.
media_encryption_enable –type route
4.2.5 Exchange 2010 Um Configuration
In order to setup TLS in Exchange 2010 UM the following shall be configured.