EVS XTnano Version 10.04 - January 2011 Configuration Manual - Manual (Page 58)

Issue
10.04.A XTnano – Version 10.04 – Configuration Manual
EVS Broadcast Equipment SA – January 2011
50
C
HANNEL
/D
EVICE
This parameter specifies the channel that the GPI will affect or the device that
will send the GPI to the server.
A device can be an EVS Remote #1. If the operator selects EVS Remote #1, the
GPI will trigger the selected action on all channels controlled by that Remote
Panel.
F
UNCTION
This parameter specifies the function that the GPI will trigger: Play, Pause,
Recue, Previous (recue to previous clip inside the playlist), Next (go to next clip
inside the playlist), Skip (skip the next clip in the playlist), -------- (no action is
taken) or Tally. For more information on the possible functions, refer to the
explanation on page 4 of the Setup Configuration in Multicam.
For the pinout of the GPI connector and wiring instructions, please refer to the XT
Tech Ref Hardware manual.
3.14.3 GPI
S
IN D
ELAY
GPI IN Settings p.8.4
GPI# Delay GPI# Delay
1[F1]Disable 5[F5]Disable
2[F2]Disable 6[F6]Disable
3[F3]Disable 7[F7]Disable
4[F4]Disable 8[F8]Disable
[Menu]Quit [Clr+F_]Dft [F9]PgUp [F0]PgDn
Possible values: Disable (default, immediate reaction), or 00s01fr to 02s00fr
This parameter defines the number of seconds and/or frames that the server will
wait after receiving the GPI IN signal to execute the GPI-related function.
3.14.4 GPI
S
OUT D
EFINITION
GPI OUT Settings p.8.3
GPI# Function Type
1[F1]------------ [F5]------------
2[F2]------------ [F6]------------
3[F3]------------ [F7]------------
4[F4]Replace [F8]Open Pulse
[Menu]Quit [Clr+F_]Dft [F9]PgUp [F0]PgDn