Hotchkis 22414F Scion xA-xB Sport Front Sway Bar - Manual (Page 2)

8) Carefully pull down on the back part of the
subframe, giving you access to the rear
anti-sway bar.
9) Take the factory end link and remove the
nuts that hold it all together using 14mm
wrenches
10) Use a 12mm socket to remove the two
bolts holding each stabilizer bar bracket
11) Carefully pull the passenger side arm of the sway bar over the steering arms, then pulls
the bar out by carefully twisting the bar over the steering hoses.
12) Please note the location of the factory
bushings on the stock setup. You are
going to install the new polyurethane
bushings in the same location.
13) Install the new Hotchkis bar in the
reverse manner that you used on the
stock bar.
14)
Carefully spread an even layer of
grease on the inside of the Hotchkis
bushings and install onto the bar. Pay
attention to the direction the split is
oriented. You want the split to face the rear of the car when the bar is installed in the.