Hotchkis 3002 1979-1993 Mustang Caster Camber Plate - Manual (Page 2)

7.) Place the spacer sleeve and washers on the strut shaft. Depending on what kind of strut
your using the amount of spacer washers will very. We recommend to start with one then
work your way up. What the spacer washers are for is to figure out how much the strut
shaft sticks out of the Delta
 plates for hood clearance. Do not close hood before
checking.
8.) Re- attach the strut to the spindle
9.) Insert the strut shaft through the Delta
 plate. Then place the polyurethane bushing with
the beveled edge up. Put on the flat washer and the strut nut, tighten with impact wrench
or open end wrenches until polyurethane just starts to bulge at sides. Make sure both
polyurethane bushings; spacer and spacer washers are installed. See Drawing on
next page.
SLEEVE