Hotchkis 2233 88-98 GM 1500 4wd Pickup Sport Sway Bars User Manual
Page 4
Advertising
2.
Raise rear end and place axle on jack stands.
3.
Assemble the dog bones and upper frame brackets on the rear bar. NOTE: Lightly pre-
grease all pivot points with supplied grease. Note hardware placement in picture. Also see
attached page.
4.
Lift the brake lines to allow the U-bolts to pass under. Place the U-bolt around axle and
in the center of the rear shock brackets. Hang the assembled sway bar onto the axle
placing the U-bolts thru the axle brackets and the bushing brackets. (NOTE: one extra
pair of hands is recommended for this operation.)
5.
Make sure the axle brackets are parallel to the ground and snug the U-bolts around the
axle.
Note
hardware
placement.
Make sure the axle
bracket is parallel to the
Advertising