Hotchkis 22801 Audi B5 Sport Sway Bar Set - Manual (Page 5)

11/
Now, install the last 4 bushing bracket bolts and washers using the 13mm
wrench and tighten. Remember, the black bracket is slotted so if all
hardware is loose enough, you will be able to thread the bushing bracket
bolts through the sub-frame and into the aluminum.
12/
Finally, choose the ‘soft’ or ‘hard’ setting for the end links and reinstall the
nuts using the 16mm wrench and 5mm allen.
13/
Now that the end link nuts and bushing bracket bolts are tight, tighten the
bolts that attach the black brackets to the aluminum pieces (13mm wrench).
Then, tighten the black brackets to the frame using the 14mm wrenches.
*BY NOW, ALL 12 BOLTS AND 4 NUTS SHOULD BE SECURE
YOU’RE DONE WITH THE REAR, NOW THE FRONT!!
1/ Raise vehicle using a 4-wheel lift or ‘drive-on’ ramps preferably, or the
front using jack stands at the named jack points. When using jack stands,
always utilize a level surface.
2/
Once vehicle is raised, use a standard screwdriver and remove the aero-
pan fasteners. Then remove the pan entirely exposing the anti-roll bar.
3/
Take a moment and observe the stock front bar and the way in
which it is mounted.
4/
Remove the lower end link bolts and nuts (16mm wrench) to the bar and
save only the bolts for re-installation. Remove the four bracket nuts and save.
(13mm wrench) Remove the stock bar.