Hotchkis 2282R Sway Bars, Rear, 64-72 GM A-Body, Extreme - Manual (Page 2)

2282R 1964-1972 GM A Body
Hotchkis Sport Suspension LLC.
2
Lube the polyurethane bushing surface on both dogbone end links. Look at your
dogbone and notice that the bushing sleeves on each end have different inner
diameters. The trailing arm bolt will use the small sleeve and the sway bar bolt will use
the large hole. Use the 7/16” x 4” bolt to attach the end link to the trailing arm. The bolt
should be pointing inboard. Use the 7/16” SAE washer (small) on the bolt head side
and the 7/16” USS washer (larger) on the nut side. Do not fully tighten at this time.
3. Attach Sway Bar to the End Links
Orient the sway bar so that the Hotchkis sticker is right side up. At this time you can
choose the stiffness setting by using the hole at the end for a softer setting or the 2 nd
hole from the end for a harder setting. use the ½” x 3” bolt to attach the sway bar to the
end link. The bolt should be pointing inboard. Use the ½” SAE washer (small) on the
bolt head side and the ½” USS washer (larger) on the nut side. Do not fully tighten at
this time.
4. Install Axle Brackets
First step is to install the provided stainless steel U-bolts. Each U-bolt will install a little
inboard of the spring mount. You will have to unclip the brake line from the axle tab and