Under body brace installation – Hotchkis 1416 2005-2011 Ford Mustang K Member Brace User Manual
Page 2
Advertising
05-Current Ford Mustang
Hotchkis Performance LLC.
2
UNDER BODY BRACE INSTALLATION
1.
Safely raise the vehicle and unbolt the stock center bar.
NOTE: This is the only stock part that needs to be removed before installation. If it is a later
model Mustang where there studs, the nuts w ill be used in the installation. If there are holes
instead of studs, use the supplied hardware.
2.
Install the new under brace by hand tightening the four (4) nuts/bolts. If only
holes are there use supplied 12mm X 30mm bolts, nylock nuts, and washers.
NOTE: Do not tighten these bolts yet. Just start the bolts in the holes so that the brace is
supported. This will make it easier to bolt up the rear section.
Advertising