Hotchkis 80116 TVS System, Stage 2, 10-11 Camaro, Track Pack User Manual
Page 11
Rear Sway Bar Installation
1R
Raise the Vehicle
Raise rear of the vehicle by driving the rear of the vehicle onto floor ramps. You may use floor jacks to jack up the
rear of the car, but the installation is easier with the suspension at ride height. Once the rear of the vehicle is
accessible, securely block the front wheels of the vehicle.
2R
Disconnect the Rear End Links
Disconnect the rear end links from the sway bar ends on each side.
3R
Detach the Sway Bar Bushing Brackets
The sway bar is attached by 2 bushing brackets, one on each side. Undo the 2 bolts per bracket to detach the
sway bar from the subframe. The bar should be loose from the vehicle. There is enough room to fish the bar
completely out without
dropping the exhaust.