Hotchkis 80014 TVS System, 67-69, Camaro-Firebird GM F-Body, Big Block - Manual (Page 10)

1967-1969 GM F Body
Hotchkis Performance LLC.
10
1R. Remove the lower rear seat cushion. If the cushion won’t pull up easily, use a long
screwdriver to push and release the small bar that is clipped in the bracket. Remove
the two bolts that hold the back part of the seat to the body and lift the upper cushion
to remove it from the vehicle. This will allow you to access the floor pans.
2R. Jack up the vehicle and properly support with jack stands or lift jacks. Make sure the
rear end is supported with the vehicle’s load on the leaf springs. This is to ensure you
install the rear bar in the proper position.
3R. Take the 7/8” bushings and grease the inner surface with the included white silicon
grease.
Installation of Hotchkis Rear Sway Bar