Hotchkis 80006 TVS System, Sport, 68-70, GM A-Body, Small Block User Manual

Installation instructions

Advertising
background image

1201AA

78-88 GM A/G-BODY

Double Adjustable Trailing Arms

Thank you for your purchase from our new line of GM parts.

Please call us at (877) 4NO-ROLL if you have any questions

regarding the service or installation of your Hotchkis products.

Visit us online @

www.hotchkis.net

W arning: This installation should be performed by a trained professional.

INSTALLATION INSTRUCTIONS

1. First, raise the rear of the vehicle so that the rear wheels are off the ground. If you are using a 2-post lift,

support the differential with a hydraulic tranny jack.

2. Remove the rear shocks.

3. Remove the rear sway bar from the lower trailing arms.

4. Allow the differential to droop as far down as possible.

5. Remove the stock upper trailing arms.

6. As an initial starting point, set the Hotchkis trailing arms to the same length (hole to hole) as the stock

pieces. Do not fully tighten the jam nuts yet.

7. Reinstall the Hotchkis trailing arms in the same manner as stock removal.

8. Continue to the next section “Setting Pinion Angle”

Advertising
Table of contents