Hotchkis 4015 111" Wheelbase Dodge, Plymouth A-Body Sub Frame Connectors - Manual (Page 10)

4014
Hotchkis Performance LLC.
10
Next, weld the rear bracket to the rear frame rails. There are 4 rosette holes on each
side of the rear mount. Rosette weld these holes and weld the rest of the mount as
shown below. Repeat on other side of the bracket.
If you find that the rear section of the bracket has too much gap between the bracket
and the frame rail, you can use vise grips to squeeze the sides together to take up the
gap. Likewise, if you have too much gap between the bottom of the bracket and the
bottom of the frame rail, then you can use a hammer to slightly bend the bottom
portion of the bracket up to close the gap. The bracket was designed with reliefs at the
bend area for this purpose.