Hotchkis 80002 TVS System, Sport, 64-66, GM A-Body, Small Block - Manual (Page 2)

2. There are various methods for installing your new upper trailing arms. Preferences in methods are mainly
based on the way you remove the old rubber Can Bushings from the differential. Some may find it easier
to detach the entire differential (rear end) from the car in order to remove the Can Bushings. This makes it
easier to get at the Can bushings for removal and replacement. The only problem with this method is that
it requires much more to be disconnected e.g. brake lines, parking brake, axle u-joint, and lower trailing
arms. However, it is possible to remove the Can Bushings without taking the rear end off the car, but it’s
tricky.
In this manual, we will describe how to replace the Can Bushings without removing the rear end from the
car.
3. First, raise the rear of the vehicle so that the rear wheels are off the ground. If you are using a 2-post lift,
support the differential with a hydrailic tranny jack.
4. Remove the rear shocks.