MSD 7562 Programmable Launch Boost Controller Installation - Manual (Page 19)

INSTALLATION INSTRUCTIONS 19
MSD IGNITION • 1490 HENRY BRENNAN DR., EL PASO, TEXAS 79936 • (915) 857-5200 • FAX (915) 857-3344
TEST EXAMPLE 9 - FIGURE 14
In this figure we see the MAP value placed on the target pressure plot for comparison. The boost
pressure followed the target fairly close until the engine reached about 7,800 rpm. At that point, the
exhaust pressure began opening the waste gate until the RPM reached about 8,150.
Figure 14