MSD 7562 Programmable Launch Boost Controller Installation - Manual (Page 9)

INSTALLATION INSTRUCTIONS 9
MSD IGNITION • 1490 HENRY BRENNAN DR., EL PASO, TEXAS 79936 • (915) 857-5200 • FAX (915) 857-3344
CONFIRM OPERATION
Prior to starting the engine you can confirm your installation. Connect your PC to the Controller
and open the MSD Graphview software. Turn the ignition On and the Controller information should
load to the screen. The screen will display the monitored items on the left side, such as the PWM,
RPM, TargetPSI, RefPSia, and others (Figure 5). The Data Editor menu tree is accessed to change
any of the program values. When you eventually start the engine, the monitor shows the data in
real time at about 10 samples per second.
At this point, you can confirm that the Controller is wired correctly by cycling the Launch wires,
Light Blue and Dark Blue. The Light Blue wire is used to reset and arm the sequence and recording
function while the Dark Blue activates the two. Cycle the Light Blue to 12 volts then open, followed
by the Dark Blue wire to 12 volts, then open. You can confirm that the system is functioning properly
on the PC screen as the LaunMode will display Run.
Figure 5 The MSD Graphview Screen.