Shogun Motorsports Honda CBR600RR (07-12) Frame Slider - Manual (Page 6)

6.
Using a small drill 1/8 inch or so drill a pilot hole in the body(see above photo). Remount
bodywork and double check the hole location with the spot tool still inserted (arrow in picture
below is pointing to spot tool). With pilot hole cut and on center, remove body panel to prep for
cutting.
7.
A pencil was then used to draw our diameter of desired shaped hole using a compass tool. A
flexible hole template can also be used for the same purpose. Place the hole template on center
of the pilot hole (or spot tool) and draw your desired diameter.