Velleman VMB4PD - Manual (Page 15)

VMB4PD 15
Addressing
Every module connected onto the Velbus ® system must have a unique address which can be set via the
configuration menu.
Make sure to synchronize the IR transmitter/receiver by setting the correct address.
The final digit represents the address to be entered into the IR transmitter (see manual for the VMBIRTS
transmitter).
Example: push button model address = 26, IR transmitter address must be 6.
1. Hold the configuration button pressed for 4 seconds to display the configuration menu.
2. Press the configuration button again to display the configuration menu.
3. Press the upper right button to display the address menu.
4. Press the upper left button to select the left address digit (blinking digit).
Press the upper right button to select the right address digit (blinking digit).
Hold the lower left button pressed and press the lower right button to modify the selected
address digit. Select an address between “00” and “FE”.
5. Press the configuration button to quit the address menu.
Remarks:
• Make sure every module has a unique address.
• The module will automatically quit the configuration mode after 30 seconds of inactivity.
Configuration button
Next configuration menu
Addressing
Quit configuration menu
Left address digit Left address digit
Modifying address Modifying address digit
Quit address menu