Velleman VMB4PD - Manual (Page 2)

VMB4PD 2
Introduction
This unique panel will let you control all of the output modules on the Velbus
® system. There is no need to
remember the function of each button, just read the label next to it!
The module also features programmable timing functions to automate daily or weekly button press actions.
The infrared receiver will let you control the module at distance.
Features
Four push buttons and one configuration push button.
Up to 8 commands (2 groups of 4 commands each).
The 2 command groups are directly callable through the configuration push button.
Automatic switchover to the first group of commands after 15 seconds of inactivity.
Push button debounce: 65ms.
Possibility for each push button to react only when maintaining pressed (1s, 2s of 3s).
Adjustable push button backlight: off – low dimming – high dimming – max. intensity.
LED indication for each push button: slow, fast, very fast blinking or continuously on.
Remote Control:
Built-in IR receiver for use with the Velbus
®
Can be used with the VMBIRTS IR remote stick
IR modulation: RECS80
Transmitter/receiver range: ±10m
LCD display:
2 lines of 16 characters
White backlight
Adjustable backlight: off – low dimming – high dimming – max. intensity.
Possibility to automatically adjust the backlight intensity (twice a day).
Adjustable contrast through configuration menu.
Labelling on the display for each command, 2 lines of 16 characters for each label
Configuration:
Adjustable display contrast and backlight.
Adjustable push button backlight.
Adjustable command reaction time (at once, 1, 2 or 3 seconds)
Command labelling.
Module address configuration (256 possible addresses).
Clock configuration.
Mode configuration (command panel only, command panel with timer or command panel with timer for the
2
nd group of commands).
Input and modification of the timer program steps.
Timer activation or deactivation for a specific push button.
Configuration menu will automatically close after 25 seconds of inactivity.
Clock:
Built-in clock with day display.
Setting one clock will adjust all other clocks on the Velbus
®
system.
Possibility to configure one clock as main clock – all other clocks will run right.
Timer:
Programmable timer functions for push button command automation.
Up to 20 program steps.
Each program step can automate up to 8 commands.
Push Button and Timer Module
for Velbus
®
System VMB4PD