Velleman VMB4PD - Manual (Page 20)

VMB4PD 20
Setting the User Mode
The module can be used as a control panel or as a control panel with timer.
The commands can be automated if the timer function has been activated. It is like you would activate a
command at a particular time of the day.
The timer function can be applied to all commands (Timer mode:8CH) or to the second set of commands
only (Timer mode:4CH).
1. Hold the configuration button pressed for 4 seconds to display the configuration menu.
2. Press the configuration button again to display the configuration menu.
3. Press the upper left button to display the mode menu.
4. Press the upper right button to set the user mode.
Following user modes are available:
“OFF”: control panel only
“4CH”: control panel with timer function for the second set of commands (commands 5 ...8)
“8CH”: bedieningspaneel met schakelklokfunctie op alle bedieningen
5. Press the configuration button to quit the mode menu.
Remark:
• The module will automatically quit the mode menu after 30 seconds of inactivity.
Configuration button
Next configuration menu
Modemenu
Quit configuration menu
Modify mode settings
Quit mode menu