Velleman VMB1RY - Manual (Page 8)

Velbus manual VMB1RY– edition 1 – rev.1.0
8
USE
Remove the lid from the dimmer module using a small screwdriver and modify the configuration.
Replace the lid
Termination
If the module is connected at the start or end of a cable on the VELBUS, place the ‘TERM’ jumper.
Remove the jumper in all other cases.
L H
PB -
BUS
+
12V
-
NO NC COM COM
MODE
TIME1
TIME2
ADDR
TERM
VELBUS
Direct push button control 12V supply
Operation mode LED
Manual control
Termination
Relay-on indication LED
Normal open contact Normal closed contact
Forwarding LED
Reception LED
Power LED
Address setting
Control mode setting
Time setting
Remark: If different cable wiring topologies (tree, star, loop, ...) are used, place a jumper on the end module of
the longest cable only, NOT on each end point.