Velleman VMB1RY - Manual (Page 9)

Velbus manual VMB1RY– edition 1 – rev.1.0
9
Addressing:
Enter a unique address (from ‘00’ to ‘FE’ except for ‘81’, ‘91’, ‘A1’, ‘B1’, ‘C1’, ‘D1’, ‘E1’, ‘F1’ and ‘FF’) for each
module through the ‘ADDR’ rotating switches. These addresses can be used to learn the push buttons.
In case of a modification of the addresses, the lamp will be switched off and all LEDs of the corresponding control
push buttons will be turned off.
Timer time setting:
A timer time will be chosen depending of the setting of the ‘TIME’ rotary switch:
TIME1 Description
0 Moment control (the relay is switched on as long as the push button is pressed)
1 5s timer
2 10s timer
3 15 timer
4 30s timer
5 1min timer
6 2min timer
7 5min timer
8 10min timer
9 15min timer
A 30min timer
B 1h timer
C 2h timer
D 5h timer
E 1day timer
F On/off control (the relay is switched on while pressed and switched off with a next press)
Operation mode/time2:
The relay module will operate as follows, depending on the setting of the ‘MODE/TIME2’ rotary switch:
MODE/
TIME2
Operation mode Description
0 Start/stop timer Operating the push button will switch on the relay. After the set time
(see ‘TIME1’ rotary switch) has elapsed, the relay turns off.
Operating the push button when the relay is switched on will
immediately switch off the relay.
1 Staircase lighting timer Operating the push button will switch on the relay. After the set time
(see ‘TIME1’ rotary switch) has elapsed, the relay will turns off.
Operating the push button when the relay is switched on will restart
the timer.
2 Non-restartable timer Operating the push button will switch on the relay. After the set time
(see ‘TIME1’ rotary switch) has elapsed, the relay turns off.
Operating the push button when the relay is switched on has no effect.
3 Switch-off delay The relay will be switched on as long as the push button is operated.
Releasing the push button will start the timer. After the set time (see
‘TIME1’ rotary switch) has elapsed, the relay turns off.
4 Switch-on delay Operating the push button will start the switch-on delay. The relay will
only be switched on after this switch-on delay (see ‘TIME1’ rotary
switch) has elapsed.
Operating the push button when the switch-on delay is running will
immediately switch off the switch-on delay.
Operating the push button when the relay is on will immediately switch
off the relay.
5 Start timer with push button
release The relay switches on during the set time (see ‘TIME1’ rotary switch)
by releasing the push button.
6 Blink timer Operating the push button will make the relay blink. After the set time
(see ‘TIME1’ rotary switch) has elapsed, the relay turns off.
Operating the push button while the relay is blinking will immediately
switch off the relay.