Badger Meter 340 BN/MB Btu Energy Transmitter - Manual (Page 17)

8 When communication has been confirmed, click on the Parameters button The Parameters screen is displayed
Figure 21: Parameters Screen
9 From this screen set up the following:
1 Flow Sensor Type, Scaling and Units
2 Temperature Sensor Type, Units, Mode and Zeroing
3 Energy Calculation Units of Measure
4 Filter Coefficients (Flow and Energy averaging for reading stability)
5 Scaled Pulse Output Resolution and Pulse Width
6 RS-485 Network Configuration (BACnet or Modbus)
10 Be sure to press Send before leaving this page to save any wanted changes
Refresh rereads the unit and refreshes the screen Defaults will restore all factory settings Exit returns to the Main
Screen
Figure 22: Parameter Screen Buttons
Installation & Operation Manual
Page 17 July 2012