Banks Power Ford Trucks: (Diesel ’94 - 97 7.3L Power Stroke) Speed Control- Banks Exhaust Brake '94-97 User Manual
Page 6
6 |
9 6 9 7 9 v . 5 . 0
17
. Install
1
⁄
8
"-NPT bronze filter into
solenoid valve port marked “#3”.
18.
Mount solenoid valve assembly
to firewall using existing factory
screw as shown in Figure 4.
19.
Install supplied vacuum hose
onto 90° fitting on the brake actuator
housing using supplied green spring
band clamp. Route the vacuum hose
along the factory air conditioning
lines mounted to the firewall. Attach
free end of vacuum hose to solenoid
valve port marked “#2” using one of
the supplied green spring band
clamps. (NOTE: Trim vacuum hose as
required).
20.
Secure the vacuum hose using
supplied cable ties as needed to
prevent the hose from contacting any
objects that may damage the hose
(i.e. heat, sharp edges, etc.).
21.
Locate and cut the factory
vacuum line and install supplied T-
fitting as shown in Figure 5 using the
two (2) supplied red spring band
clamps.
22.
Install the supplied vacuum
hose onto solenoid valve port
marked “#1” using supplied green
spring band clamp.
23.
Install free end of vacuum line
onto open port of previously installed
T-fitting using supplied green band
clamp (see Figure 5).
Figure 4
Figure 5