Banks Power Ford Trucks: (Diesel ’94 - 97 7.3L Power Stroke) Speed Control- Banks Exhaust Brake '94-97 User Manual
Page 8
29.
Route the brown wire pair to
the brake pressure switch located on
the forward side of the brake master
cylinder. See Figure 8.
30.
Locate the black wire with the
yellow stripe at the brake pressure
switch.
31.
Cut the black wire with the
yellow stripe approximately 2 inches
from the brake pressure switch. Note:
The factory tape and convolute wire
cover may need to be trimmed back
to expose the wires within. Strip
3
⁄
16
"
of insulation from each end of the
cut wire. Crimp the supplied male
and female wire connectors to the
ends of the brake pressure switch.
32.
Connect the brown wires in the
banks brake harness to the wire
connectors at the brake pressure switch.
33.
Connect the green and black
banks brake wires to the black
solenoid valve wire leads.
34.
Route the gray lead from the
harness toward the front of the
engine. Locate the red wire with
white stripe on the ECT sensor (see
Figure 9). Install a red T-tap onto the
wire and plug the connector on the
gray wire into the T-tap.
35.
Locate the two gray wires with
yellow stripes. The wires are located
on the bottom side of the steering
column, under the dash.
36.
Install supplied blue T-tap on
the SMALLER gray wire with yellow
Figure 9
Figure 8
8 |
9 6 9 7 9 v . 5 . 0