Banks Power Ford Trucks: (Diesel ’94 - 97 7.3L Power Stroke) Speed Control- Banks Exhaust Brake '94-97 User Manual
Page 9
9 6 9 7 9 v . 5 . 0
| 9
stripe located in previous step. Plug
connector on end of banks brake
power wire (black, fused wire) into T-
tap connector (See Figure 10).
37.
Locate the Gray wire with white
stripe at the connector near the top
of the throttle pedal assembly. Install
a red T-tap on the gray wire with
white stripe and plug connector on
end of blue wire from harness into
red T-tap. See Figure 11.
38.
Using the supplied M8X1.25 nut,
install the ground wire ring terminal
onto the steering column bracket
stud. See Figure 11.
39.
The CBC module is to be
mounted on the dash support
bracket as shown in Figure 11.
Ensure that the mounting surface of
the dash support is clean and free of
oil, grease, and dirt. Clean and dry as
required using a cloth and rubbing
alcohol or similar solution.
40.
Peel the protective backing from
the foam tape on the CBC module
and mount the CBC module to the
dash support as shown in Figure 11.
The CBC module should be oriented
with the connector facing down.
Apply light pressure to the CBC by
hand for 60 seconds to seat the foam
tape and create a strong bond.
41.
Plug the supplied 2 amp fuse
into the fuse holder on the harness.
42.
Plug the harness into the CBC
module.
Figure 10
Figure 11