Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner w optional Speed-Loader Module, (325 HP Dodge 5.9L Cummins 600 (24-valve) Trucks) '04-05 For use with Six-Gun Switch User Manual
Page 12
12
96464 v.4.0
CAUTION: It is very important that
you select the proper wire. The
Banks Six-Gun Diesel Tuner will
not function properly if installed
incorrectly.
2004-2005 vehicles with automatic
transmission, follow Steps 13 through
15. Vehicles with manual transmission,
skip to Step 16.
FOR AUTOMATIC TRANSMISSION
VEHICLES ONLY:
13.
Plug the TCC extension into the
BLUE Tcc wire. Using the wire harness
on the two (2) connectors next to the
main brake cylinder as a guide (see
Figure 8), route the BLUE and GRAY
Tcc wires toward the transmission
solenoid assembly that is sitting on the
transmission. It is located underneath
the drivers side of the vehicle. See
Figure 9. Secure the wire using cable
ties along the way.
14.
Find the YELLOW wire with
orange stripe on the solenoid
assembly. (There is a YELLOW wire
with a PINK stripe next to the YELLOW
wire with ORANGE stripe and it
may appear as a YELLOW wire with
ORANGE stripe. Do Not t-tap this
YeLLoW WIRe with PINK stripe!) Refer
to Figure 10 for the correct YELLOW
wire with ORANGE stripe pin number
and location. It is at pin #1. Apply
a generous amount of the supplied
dielectric grease into a T-tap and
install it on the YELLOW wire with
ORANGE stripe. Insert the BLUE Tcc
wire into this T-tap. See Figure 11
15.
Find the YELLOW wire with light
BLUE stripe. Apply a generous amount
of the supplied dielectric grease into a
T-tap and install it on this wire. Insert
the GRAY Tcc wire into this T-tap. See
Figure 11. Proceed to Step 16 for
2004 automatic or proceed to Step 17
for 2005 automatic.
Figure 7