Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner w optional Speed-Loader Module, (325 HP Dodge 5.9L Cummins 600 (24-valve) Trucks) '04-05 For use with Six-Gun Switch - Manual (Page 27)

96464 v.4.0
27
Note: this procedure should only be
performed if:
(a) A ”4,2” code for transmission slip
detection is repeatedly set or will
not clear and the transmission is not
actually slipping; or
(b) The Six-Gun Diesel Tuner is moved
to a new vehicle; or
(c) The speedometer has been
recalibrated for different gearing or tire
size; or
(d) Instructed to do so by Banks
Technical Staff.
Your Six-Gun Diesel Tuner also has
the capability to clear the information
related to the learned transmission
type and gear ratios. The diagnostic
code “4, 3” will reappear after the
procedures are carried out correctly.
Follow the steps below to unlearn the
transmission on your Six-Gun Diesel
Tuner.
CAUTION: The following procedures
can only be carried out with the
engine off.
B1. Turn the vehicle key to the ON
position but DO NOT start engine.
B2. Fully depress the throttle pedal
and then release it completely. Repeat
for 5 times. The green LED will flash
when this is completed successfully.
B3. Turn key off. Wait 10 seconds or
until the green LED goes off and stays
off. Turn key to on position but do not
start engine.
B4. Fully depress the throttle pedal
and then release it completely. Repeat
for 5 times. The “4,3” diagnostic code
will display when this is completed
successfully.
Note: When the transmission type and
gear ratios are cleared (with code “4,3”
displayed), the engine power returns and
remains in stock level until the Six-Gun
Diesel tuner re-learns the transmission
and code “4,3” is eliminated. Follow the
procedures in Section 4’s LeARNING
tRANSMISSIoN to eliminate code “4,3”.
-END, SEcTION 8-
SECTION 8
CLEARING TRANSMISSION INFORMATION
Figure 19