Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner w optional Speed-Loader Module, (325 HP Dodge 5.9L Cummins 600 (24-valve) Trucks) '04-05 For use with Six-Gun Switch - Manual (Page 18)

18
96464 v.4.0
10.
Install the knob onto the shaft
facing the #1 Level on the Six-Gun
label. On the knob, snug the two (2)
set screws with the supplied 0.050”
hex key wrench.
11.
Reinstall the cluster bezel by
pressing on it to ensure all the clips
are engaged. Secure it with the
original two (2) screws.
12.
Reconnect the electrical
connector to the headlamp switch
bezel. Reinstall this bezel by gently
pushing on it until all clips are
engaged.
13.
Reconnect the four (4) electrical
connections to the center bezel.
Reinstall this bezel by pushing on it to
engage all the clips. Open the ashtray
and cup holder and reinstall the
original screw.
14.
Route the Six-Gun switch wires
down to the steering column.
15.
Remove the 2-pin jumper from
the Six-Gun Diesel Tuner wire harness.
Connect this Six-Gun harness to the
2-pin connector on the switch wire.
If the thermocouple is not being
installed, skip to Section 4, Preforming
transmission Learning Procedure on
page 21.
-END, SEcTION 2-
Figure 16
Figure 15