Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner w optional Speed-Loader Module, (325 HP Dodge 5.9L Cummins 600 (24-valve) Trucks) '04-05 For use with Six-Gun Switch - Manual (Page 7)

96464 v.4.0
7
CAUTION! Do not use floor jacks to
support the vehicle while working
under it. Do not raise the vehicle
onto concrete blocks, masonry
or any other item not intended
specifically for this use.
5.
The installation should be
performed at a time when the vehicle
has been allowed to completely cool.
This installation requires the installer
to work near surfaces that may remain
hot after the vehicle has been run.
Failure to allow the vehicle to cool
may result in personal injury.
6.
During installation, keep your work
area and components clean to avoid
possible dirt entry into the engine.
7.
Save this Owner’s Manual as a
reference for system maintenance and
service.
8.
Banks recommends that a
Pyrometer (EGT) gauge and a Boost
gauge be installed with the Six-
Gun Diesel Tuner to help monitor
performance and exhaust gas
temperature of the vehicle (see part
numbers below). To further increase
engine life by lower EGT’s, Banks also
recommends installing the following
airflow improvements:
Airflow Improvements:
1. Banks Monster Exhaust,
325-hp Rated Engines
Std. cab Long Bed . . . . . . . . . 48700
Quad cab Short Bed . . . . . . . 48700
Quad cab Long Bed. . . . . . . 48701
2. Banks Ram-Air ®
Filter . . . . . . . . . . . . . . . . . . . 41028
Service Kit. . . . . . . . . . . . . . . 90094
Gauges:
1. Gauge Assembly
Boost and Pyro*. . . . . . . . . . 64507
2. Thermocouple**. . . . . . . . . . . . 63042
3. Lead wire** . . . . . . . . . . . . . . . 63061
4. Turbine Inlet Gasket* . . . . . . . . 93033
* also available separately
** included with Speed-Loader
Tools Required:
These tools are necessary for the
installation unless otherwise specified.
•
1 ⁄
4
” and 3 ⁄
8
” drive ratchets with
Standard and metric sockets including
5 ⁄
16
”, 7 ⁄
16
” deep 1 ⁄
4
” drive sockets and
a 1 ⁄
4
” drive extension
• Standard and metric combination or
open-end wrenches
• Standard and Phillips head
screwdrivers
• Standard and needle-nose pliers
• Pocket or X-Acto knife
• Clean shop towels or rags
• Drill motor
•
1 ⁄
8
” and 3 ⁄
8
” drill bits
• Wire crimping/stripping tool
Tools Required for Optional Speed-
Loader Installation:
•
7 ⁄
16
” drill bit
• Tap Handle
•
1 ⁄
4
” NPT tap
• 12mm, 12-point socket & wrench
Highly recommended tools and
supplies:
• Multimeter or 12-volt test light
• Heat gun