Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner w optional Speed-Loader Module, (325 HP Dodge 5.9L Cummins 600 (24-valve) Trucks) '04-05 For use with Six-Gun Switch - Manual (Page 16)

16
96464 v.4.0
16.
FOR 2004 (325-HP): Locate the
two (2) electrical connectors next
to the main brake cylinder. Find
the PINK wire with GRAY stripe on
the connector closest to the brake
cylinder. Install a T-tap on this wire.
Plug the Six-Gun Diesel Tuner RED wire
into the T-tap. See Figure 12. Proceed
to Step 18.
17.
FOR 2005 (325-HP): Locate the
two (2) electrical connectors next
to the main brake cylinder. Find the
PINK WIRE with GRAY stripe on the
connector furthest from the brake
cylinder. Install a T-tap on this wire.
Plug the Six-Gun Diesel Tuner RED wire
into the T-tap. See Figure 13.
18.
Inside the cab, plug the main
8- and 10-pin connectors from the
wire loom into the front of the
Six-Gun Diesel Tuner box. On vehicles
with automatic transmissions, plug the
4-pin Tcc wire harness connector
into the rear of the Six-Gun Diesel
Tuner box.
19.
In the engine compartment,
unbolt the nut from the ground (-)
terminal on the drivers side battery.
Locate the ring terminal on the Six-Gun
Diesel Tuner wire harness. Install this
ring terminal onto the battery ground
and re-install the nut. See Figure 14.
Note: Go over the entire installation as
a precautionary check to ensure that all
clamps are tight, wiring and hoses are
properly routed, and connections are
correct and tight. Make sure that the
wire harness is not lying in the way of
the brake and gas pedals.
-END, SEcTION 1-
Figure 14