Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner w optional Speed-Loader Module, (325 HP Dodge 5.9L Cummins 600 (24-valve) Trucks) '04-05 For use with Six-Gun Switch - Manual (Page 8)

8
96464 v.4.0
SECTION 1
Six-Gun Diesel Tuner Installation
1.
Locate the rubber grommet on the
drivers side firewall. Using a utility
knife, make a 1.5-inch-long slit in the
grommet next to the wire harness.
Be careful not to cut or damage
the harness. See Figure 1 for the
proper location of the required cut.
Insert a screwdriver from the engine
compartment into the cut hole and
thrust it through the grommet.
2.
Inside the vehicle, remove the
lower dash panel beneath the steering
column by removing the two (2)
screws at the bottom of the panel.
Retain the screws for re-installation.
Note: there are also two (2) clips
located at the top corners of the panel,
which hold the panel in place. these
clips can be released by gently pulling
on the corners of the panel. Use caution
to avoid damaging the panel during
removal.
3.
Remove the electrical connector
bracket on the left hand side of the
support below the steering column in
front of the firewall by removing the
Figure 1
Figure 2