Banks Power Ford Trucks: (Diesel ’94 - 97 7.3L Power Stroke) Speed Control- SmartLock '94-03 - Manual (Page 11)

23.
Using Figures 5 and 6 as
a guide, insert the two female
socket/wire ends from the
SmartLock harness into the
factory transmission control
wiring connector body as
follows:
A. Insert the gray wire with
the female socket into pin
#4 location of the connector.
The pin should click into place
when it is fully seated.
B. Insert the blue wire with
the female socket into pin #11
location. This pin should also
click into place when it is fully
seated.
24.
Reinstall the red plastic
wedge or retainer (removed
in Step
19 ) between the two
rows of socket pins in the
connector body.
25.
Locate the supplied
round 4-pin connector
shell pictured in Figure
7 .
Remove the red wedge from
the front of the connector.
Using Figures
5 and 7 as a
guide, insert the two wires
that were removed from the
transmission connector in
Steps 19 thru 22 into the back
of the connector shell. Be sure
to refer to the wire colors that
were noted on Figure
5 .
A. Insert the wire that was
removed from pin #4 into the
#3 hole of the connector shell
shown in Figure
7 . Be sure
that the pin clicks into place.
B. Insert the wire that was
removed from pin #11 into
the #2 hole of the connector
shell. Be sure that the pin
clicks into place. NOTE: Holes
#1 and #4 are not used.
26.
Insert the thin end
of the supplied red plastic
wedge into the front of the
connector.
27.
Inspect the new
connector assembly by double
checking the wire colors and
pulling (lightly) on the wires
from the rear of the connector
to be sure that they are fully
seated.
28.
Plug the new connector
into its mate on the
SmartLock harness and
connect the ground wire to a
transmission case bolt.
29.
Reconnect the
transmission control
wiring connector to the
transmission.
NOTE: If the connector
doesn’t “snap” into position
easily, it is possible that the
rubber seal that is supposed
to be around the Ford wire
loom connector has come off
the plug and is down inside
the transmission socket. If
this happened, remove the
seal with a small pick and
slide it over the red retainer
and try again.
30.
Re-install heat shield if it
was previously removed.
31.
Secure entire wiring
harness using supplied cable
ties. Ensure that wiring is
routed away from all heat
sources and sharp edges.
32.
The Banks SmartLock
installation is now complete.
Lower the vehicle.
9 6 9 8 1 v . 7 . 0
| 11