Banks Power Ford Trucks: (Diesel ’94 - 97 7.3L Power Stroke) Speed Control- SmartLock '94-03 - Manual (Page 6)

5.
Starting with the 10-pin
(white) connector on the
SmartLock wiring harness,
feed the wires through the
1” hole from the engine
compartment towards
the interior of the vehicle.
Continue to feed the wires
through the hole until the first
harness junction is reached
(approx. 2 feet).
6.
Locate the white electrical
junction block on the bottom
side of the steering column.
Ensure that the surface of the
junction block is clean and
free of oil, grease, dirt. Clean
and dry as required using a
cloth dampened with rubbing
alcohol or similar cleaning
solution.
CautIon: Do not spray
fluid directly onto
electrical junction
block or damage to the
electrical system may
result.
7.
Peel the protective backing
from the foam tape on the
SmartLock Trans Brake.
The SmartLock Trans Brake
should be oriented so that the
electrical connector is facing
towards the front of the
vehicle. See Figure
2 . Attach
the SmartLock Trans Brake
to the bottom side of the
white electrical junction box.
Apply light pressure to the
trans brake box by hand for
approximately 60 seconds to
seat the foam tape and create
a strong bond.
8.
Locate the end of wire
harness with white 10-pin
connector. Plug this connector
into SmartLock Trans Brake.
9.
Secure the wire harness as
necessary using two (2) of the
supplied cable ties.
10.
Re-install previously
removed fuse panel cover.
11.
On 1999-2001 models,
locate electrical connector
(C1049M) below and slightly
towards the driver side of the
brake master cylinder, on the
firewall (See Figure
3 ). The
electrical connector is the
topmost of a group of three
similarly shaped connectors.
Peel wire harness tape back
to reveal the wires within the
loom.
CautIon: Be careful not
to damage the insulation
on the wires within the
loom when removing the
tape.
Locate the white wire with
pink stripe (Pin 9 of c1049M).
CautIon: there is also
a white wire with a red
stripe in this harness. Do
not t-tap that wire.
Install the red T-Tap connector
on the white wire with pink
stripe.
On 2002-2003 vehicles, locate
the PCM electrical connector
(C175) on the driver’s side
of the firewall (see Figure
3A ). Remove PcM connector
by loosening center bolt
on connector. Remove the
black plastic cover from
PCM connector. Locate the
brown wire with orange
stripe (Pin 95). Install the red
T-tap connector onto the
brown wire with the orange
stripe (Pin 95). Plug the PCM
connector into the firewall
connector. Reinstall the black
plastic cover and tighten
center retaining bolt.
Figure 2- Positioning of SmartLock Trans Brake
6 |
9 6 9 8 1 v . 7 . 0