Banks Power Ford Trucks: (Diesel ’94 - 97 7.3L Power Stroke) Speed Control- SmartLock '94-03 - Manual (Page 13)

operating
Instructions
The SmartLock Trans Brake
is a fully automated device,
which integrates seamlessly
with the Banks Brake and
the vehicle computer. There
are no switches or buttons
to press to operate the
SmartLock. It will become
operational whenever the
exhaust brake is active (power
“ON” and no throttle applied)
and the engine speed is above
1600 rpm.
If the SmartLock Trans Brake
should ever need to be
temporarily removed from the
vehicle, the system includes
a by-pass plug that must
be connected to the white
10-pin connector in place of
the SmartLock Trans Brake.
Failure to utilize the by-pass
plug will result in a “Service
Engine Soon” light on the
dash and a Diagnostic Trouble
Code being stored in the
factory computer. note: the SmartLock is
designed to compliment
the function of the
Banks Brake. It is not
designed or intended for
use under acceleration
as a means to hold the
torque converter locked
or raise transmission
pressure. this device
does not increase the
torque capacity of the
vehicle’s transmission
under acceleration. the
Banks transCommand
transmission control
module is available for
use under acceleration/
power conditions.
9 6 9 8 1 v . 7 . 0
| 13