Banks Power Ford Trucks: (Diesel ’94 - 97 7.3L Power Stroke) Speed Control- SmartLock '94-03 - Manual (Page 5)

CautIon: Installation
of the SmartLock trans
brake is not complete
until Functional testing,
described on Page
12 of
this manual, has been
successfully completed.
note: the following
instructions assume
that a Banks exhaust
Brake system has been
previously installed on the
vehicle.
note: If the vehicle
is equipped with a
Banks transCommand
transmission Command
module, the installation
instructions for the
SmartLock do not
change. the SmartLock
is designed to work in
conjunction with the
transCommand.
1.
As a precaution,
disconnect the ground of the
battery (if there is more than
one battery, disconnect both).
2.
Remove fuse panel cover
(panel below steering column)
by loosening the four (4)
retaining fasteners with a
coin.
3.
Locate the block-off plate
on the firewall (see Figure 1
or 1A ).
4.
Using a 1” hole-saw, Drill
a hole in the center of the
block-off plate. Be sure to
de-burr both sides of the hole
in order to prevent damage
to the wiring harness. On the
1999-2003 models it may be
easier to drill the hole after removing the block off-plate
from the vehicle. Re-install
the plate after drilling. The
1994-1997 model block-off
plate can be drilled while it is
installed in the vehicle.
SmartLock trans Brake Installation
Figure 1- (’99-02 models)-Block-Off Plate on Firewall
Figure 1A- (’94-97 models)-Block-Off Plate on Firewall
9 6 9 8 1 v . 7 . 0
| 5