Banks Power Ford Trucks: (Diesel ’99 - 03 7.3L Power Stroke) Speed Control- Banks Exhaust Brake '99-03 - Manual (Page 19)

96995 v.9.0
19
43.
Secure the wire loom under the
dash and hood using the nylon ties
provided. When securing the vacuum
pump wire with the vacuum hose, use
care to avoid pinching the hoses closed.
44.
The 2-pin warm-up valve module
needs to be installed onto the warm-
up valve connector on the vehicle wire
harness. On the pedal stool under the
turbocharger, disconnect the 2-pin
connector. Attach the 2-pin connector
to the Banks warm-up valve module
and zip-tie the module and wire harness
away from any moving parts. See
Figure 15.
45.
Your System includes two (2)
Banks Power Logos that have been
designed to compliment the Ford
badging on your truck. We have
provided measurements, which will
allow you to place these logos in a
position that gives a clean factory look.
See Figure 16.
Figure 16
Figure 17