Banks Power Ford Trucks: (Diesel ’99 - 03 7.3L Power Stroke) Speed Control- Banks Exhaust Brake '99-03 - Manual (Page 6)

6
96995 v.9.0
clearance for the Brake housing. See
Figure 3. The dipstick tube should
move toward the turbo about 1” at the
bracket and about 6” at the top.
10.
Locate the engine lifting hook
at the rear of the engine on the
passenger side, bolted to the cylinder
head. Remove the lifting hook. This
will allow clearance for the installation
of the Brake. It is not necessary to
re-install the hook.
11.
Remove the exhaust backpressure
control valve assembly from the
factory turbine housing by removing
the seven (12-point, 8mm head) bolts.
Retain these bolts for reuse. Note: If
a Banks Stinger-Plus or PowerPack is
being installed, it is easier to complete
this step after the turbocharger has
been removed to accommodate the
installation of the Quick-turbo housing.
When the turbocharger has been
reinstalled in the vehicle, continue
with step 11 in these instructions.
Figure 2