Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Power Systems- PowerPack & Stinger w_EconoMind '07-10 (iQ) Compatible with Optional Banks iQ User Manual
Page 12
12
96818 v.2.0
Figure 10 Headlamp Assembly/Grill support bracket
6.
Carefully remove the transmission
module from the upper fan shroud. Lay
the module to the side. See Figure 11.
7.
Remove the low pressure A/C
condenser line from the line retainer
attached to the upper fan shroud.
8.
Remove the upper section of the
fan shroud from the vehicle. Take care
not to damage the face of the radiator
when removing the shroud.
9.
Remove the two upper condenser
mounting bolts that attach to the
radiator cross brace.
10.
Mark the location of the hood
latch, then remove the hood latch
from the latch support. The latch is
held in place by three bolts. The latch
support is shown in Figure 12. It is
not necessary to remove the cable
from the latch, just place the latch and
cable assembly out of the way.
11.
Remove the two bolts that attach
the latch support to the radiator cross
brace and the 4 lower attachment
bolts (2 per side). The two bolts that
attach the upper support to the
radiator cross brace are accessed from
the engine compartment side of the
vehicle.
12.
Only Remove the (2) top oil cooler
brackets to free the oil cooler from the
latch support bracket. See Figure 12.
13.
Swing the latch support forward
as shown in Figure 13.
14.
Pull the air conditioning
condenser out of it’s lower mounts,
and place it against the latch support.
15.
Remove the two upper Charge
Air Cooler (CAC) mounting bolts and
unfasten the fender support rod from
the cross brace as shown in Figure
14.