Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Power Systems- PowerPack & Stinger w_EconoMind '07-10 (iQ) Compatible with Optional Banks iQ User Manual
Page 5
96818 v.2.0
5
Use caution when working in the
engine compartment. Make sure the
engine has been OFF for several hours
and cool. Disconnect the ground
cables from both the driver and
passenger side batteries. Position the
loose cables so that they do not come
into contact with their respective
battery posts during the installation.
1.
Loosen the hose clamp from the
stock intake tube on the turbo intake.
2.
Loosen and separate the stock
hose clamp on the intake air tube
connected to the stock air box cover.
See Figure 1.
3.
Separate the stock intake tube
connected to the turbo intake. Remove
the stock intake tube from the engine
and set aside.
4.
Remove the Mass Air Flow (MAF)
sensor connector from stock air box
filter cover.
Note: Be careful not to damage the
connector or the MAF sensor during
this process.
5.
Remove stock air box by lifting the
air box up and out. The bottom of the
stock air box is held in place by rubber
grommets. There may be some slight
resistance when removing the stock
air box.
6.
Next, remove the stock air box
bolts accessible from the top of the
engine compartment as shown. Then
remove the stock air box tray. See
Figure 2. Keep the previously removed
bolts for reassembly later in the
installation process.
If you are installing the Banks Techni-
Cooler, skip to Section 3.
7.
Locate your Banks Ram-Air filter
housing from your kit. Align the Banks
Ram-Air filter housing to fit parallel to
fender edge. Install and tighten the
previously removed air box tray bolts
to secure the Banks Ram-Air filter
housing.
Note: the cutout on Banks Ram-Air
filter housing must face passenger side
fender. See Figure 3.
Figure 1