Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Power Systems- PowerPack & Stinger w_EconoMind '07-10 (iQ) Compatible with Optional Banks iQ - Manual (Page 35)

96818 v.2.0
35
4.
Find a suitable place on the
windshield for ease of access and
viewing of Banks iQ. Use location
shown in Figure 26 as a reference
for mounting Banks iQ in your
vehicle. Loosen the knob and move
the swivel suction plate to achieve
desired viewing angle of the Banks
iQ screen. Do a test fit and note the
angle necessary to achieve the correct
viewing angle.
5.
Make sure the suction cup and the
mounting area on the windshield are
clean and dry.. With the suction lever
in the up position, ensure the suction
cup is flat against the windshield, and
then push the suction lever down to
secure in place.
6.
Next, remove and set the fuse
access panel aside. See Figure 26.
7.
Find the Banks OBD II Interface
Cable in your kit. Connect the Banks
Interface Cable to the vehicle’s OBD II
connector. Use a cable tie as shown
in Figure 27 to secure the Banks
Interface Cable to the vehicle’s OBD II
connector.
8.
Next, connect the 6-terminal
connector on the Banks OBD II
Interface Cable to the 6-pin connector
on the Six-Gun Tuner harness.
9.
Locate the RJ12 Cable (similar to
telephone connector) on your Banks
OBDII interface cable . See Figure 28.
Figure 28 Banks iQ System