Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Power Systems- PowerPack & Stinger w_EconoMind '07-10 (iQ) Compatible with Optional Banks iQ User Manual
Page 24
24
96818 v.2.0
9.
Position the Tuner on the fuse box
cover for an idea of where to clean.
The Tuner must be mounted as close
to the inside (engine side) edge as
possible to avoid a hood clearance
issue. Check the hood clearance
before attaching the Tuner to the fuse
box. Clean the top of the fuse box
cover located on the drivers’ side of
the engine compartment. Make sure
the outside of the fuse box is free of
oil, grease and dirt.
Note: Clean the fuse box cover with a
non-oil based solvent such as Acetone,
Mineral Spirits, Denatured Alcohol or
Lacquer thinner. Read and follow the
manufacture’s operation instruction
for non-oil based solvent cleaner.
WARNING: Make sure to place
the Tuner as shown in Figure
20 to avoid a clearance issue
when closing the hood. Mount
the EconoMind Tuner as close to
the inside (engine side) edge of
the fuse cover as possible. Verify
you have hood clearance before
mounting the Tuner.
10.
Peel the protective backing
from the hook and loop interlocking
fasteners attached to the EconoMind
Diesel Tuner. Position the side edge
of the EconoMind Diesel Tuner to the
edge closest to the engine of the fuse
cover, then press the adhesive onto
the outside of the fuse box cover.
Apply light pressure to the EconoMind
Diesel Tuner by hand for 60-seconds
to create a strong bond between the
fuse box and hook & loop interlocking
fasteners. Using the supplied cable
ties, secure the wire harness away
from any heat sources or moving
components.
CAUTION: When securing the
wires, do not bend them any
tighter than a 2.5” diameter bend
as this can cause undue stress on
the wires and may cause failure.
-END, SEcTION 4-
Figure 24